One of the things that you will notice about the corners of your Loft NURBS for your mouldings and frames are the curves that they have as they round the corner...
To create a sharp corner, make the following changes:
Thanks for Prof Watkins for the tip. ;)
To create a sharp corner, make the following changes:
1. Select the Loft NURB.
2. Select the Phong Tag that is next to it (the two orange circles).
3. In the Attributes of the Phong Tag, check the Angle Limit box and set the Phong Angle to 80˚.
No the corner can be seen:2. Select the Phong Tag that is next to it (the two orange circles).
3. In the Attributes of the Phong Tag, check the Angle Limit box and set the Phong Angle to 80˚.
Thanks for Prof Watkins for the tip. ;)